Knowledge

Capacity selection of distribution transformers

Aug 07, 2024 Leave a message

In the operation of distribution transformers, there are cases of underload due to excessive capacity, as well as cases of equipment overheating or even burning due to overload or overcurrent operation. The improper selection of capacity for this device affects the reliability and economy of power supply in the power system.
The capacity of the transformer is selected based on load statistics. Due to the difficulty in accurately predicting the load, it is generally chosen based on the maximum expected load. The result of such selection often has a larger capacity setting, which has a negative impact on the operation of the power system. If selected based on economic operation, it is to use the condition that the copper loss and iron loss of the transformer are equal to derive the maximum economic load rate of the transformer and the ratio of the rated capacity of the transformer to the maximum load. Due to the fact that the actual operating load may not necessarily be the maximum load calculated from the load statistics, and the load is random, the operating efficiency varies, making it difficult to achieve its economic operating benefits.
Currently, new low loss transformers are being used in the distribution system to replace high energy consuming transformers, reducing single iron loss by approximately 40%. Due to the large number of distribution transformers and significant load fluctuations, their economic benefits are very significant.
How to fully utilize the set capacity of transformers without compromising their normal service life should be the main basis for selecting transformer capacity.
The recommended method is to select the capacity of the distribution transformer based on the maximum load Smax estimated by the load and the typical daily load curve, in accordance with the International Electrotechnical Commission (IEC) standard (1972) - Load Guide for Oil Immersed Transformers. This standard has been adopted by China. The advantage of this method is that it considers the normal overload capacity of the transformer and fully utilizes the transformer's set capacity without shortening its lifespan. This has significant economic benefits from reducing investment and improving the operating conditions of the distribution network.

 

info-750-560

Send Inquiry